BCM QS750 User Manual download pdf (Page 27)

3. Installation

Ready To Turn On Power

Check Again

1. Is the CPU installed exactly and firmly into the socket (Sec. 3.3)?

2. Are all the DRAM modules installed properly (Sec. 3.4)?

3. Did you insert the expansion card (VGA, Sound… etc.) already (Sec.

3.5)?

Are you sure that all the connectors (described in Sec 3.6) have

been connected to their variable devices (Sec. 3.6)?

Yes, I have checked and assured the above steps!

Now get ready to turn on your device by following the steps below.

1. Mount your motherboard to the chassis frame and close the case

cover.

2. Switch off all power.

3. Connect the power supply cord into inlet of the system case.

4. Connect the power supply cord into an outlet of power supply.

5. Connect Monitor signal cable to the system VGA port and the

monitor power cord to power outlet.

6. Now turn on the monitor and system power.

After Power on, The power LED on the front panel of the system case will light. For ATX

power supplies, the system LED will light when the ATX power switch is pressed.

The system will then do a power-on tests item by item, and additional messages will appear

on screen. If the screen blinks or the tests stops more than 30 seconds, the system may have

failed the power-on test. If so, please recheck the above steps or call your retailer for

assistance.

If the power-on test goes well, hold down

<F2> button on the keyboard to enter

BIOS Setup. Next, follow the instructions

in the next chapter, BIOS SETUP.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 49 50

No comments

BCM QS750 User Manual Page 27