BCM QS440VA User Manual download pdf (Page 57)

4. BIOS SETUP

Modes 0 through 4 provide successively increased performance. In Auto mode, the

system automatically determines the best mode for each device. The choices: Auto,

Mode0, Mode 1, Mode 2, Mode 3, Mode 4.

4.8.5 Init Display First

This item allows you to decide to active whether PCI Slot or AGP first. The choices:

PCI Slot, AGP.

4.8.6 Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the

system board and you wish to use it. If you install and-in FDC or the system has no

floppy drive, select Disabled in this field. The choices: Enabled, Disabled.

4.8.7 Onboard Serial Port 1/Onboard Serial Port 2

Select an address and corresponding interrupt for the first and second serial ports. The

choices: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.

4.8.8 UART Mode Select

This item allows you to determine which Infra Red(IR) function of onboard I/O chip.

The choices: IrDA 1.0, Standard, ASKIR, HPSIR.

4.8.9 RxD, TxD Active

This item allows you to determine the active of RxD, TxD. The choices: “Hi,Hi”,

“Lo,Lo”, “Lo,Hi”, “Hi,Lo”.

4.8.10 IR Transmission delay

This item allows you to enable/disable IR transmission delay. The choices: Enabled,

Disabled.

4.8.11 Onboard Parallel Port

Select a logical LPT port name and matching address for the physical parallel (printer)

port.

1 2 ... 52 53 54 55 56 57 58 59

No comments

BCM QS440VA User Manual Page 57