BCM QS440VA User Manual download pdf (Page 29)

3. INSTALLATION

Ready To Turn On Power

l Check Again

1 Is the CPU Cartridge installed exactly and firmly

into Retention Mechanism (Sec. 3.2)?

2 Are all the DRAM modules installed properly (Sec.

3.3)?

3 Did you insert expansion card (VGA, Sound…. etc.)

already (Sec. 3.4)?

4 Are you sure that all the connectors (described in

Sec 3.5) have been connected to their variable devices

(Sec. 3.5)?

l Yes, I have checked and assured the above steps!

Now get ready to turn on your device using the following steps.

1. Mount your motherboard to the chassis frame and close the

case cover.

2. Switch off all power.

3. Connect the power supply cord into inlet of the system

case.

4. Connect the power supply cord into an outlet of power

supply.

5. Connect Monitor signal cable to system VGA port, and the monitor power cord

to power outlet.

6. Now turn on monitor and system power.

After Power on, The power LED on the front panel of the system case will light. For

ATX power supplies, the system LED will light when the ATX power switch is

pressed.

The system will then do a power-on tests item by item, and additional messages will

appear on screen. If the screen blinks or the tests stops more than 30 seconds, the

system may have failed the power-on test. If so,

please recheck the above steps or call your retailer

for assistance.

If the power-on test goes well, hold down <Delete>

button on the keyboard to enter BIOS Setup. Next,

follow the instructions in the next chapter, BIOS

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 58 59

No comments

BCM QS440VA User Manual Page 29